Quantum Scalar 50 Manual de usuario Pagina 9

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 12
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 8
Quantum Scalar 50 Tape Drive Removal and Replacement Instructions
Document 81-81770-01 A01
June 2007
Replacing the SCSI Sub-Plate 9
2 Slowly insert the new tape drive into the library until the connectors are
seated.
3 Tighten the tape drive thumbscrew using a flat-blade screwdriver.
4 For SCSI tape drives, install the old SCSI sub-plate (still connected to the
SCSI bus) on the new tape drive. For native Fibre Channel tape drives,
reconnect the Fibre Channel cable to the tape drive.
5 Tighten the two sub-plate thumbscrews using a flat-blade screwdriver.
6 Return power to the drive by setting the Drive Power option to ON (refer
to the Drive Operations Screen
on page 5 for OCP instructions and Drives
Page on page 6 for GUI instructions).
The host detects the presence of the tape drive automatically.
7 If the host does not detect the presence of the tape drive, check the drive
SCSI ID (from the OCP, select
Setup, Cabinet, and Host bus to view the
SCSI IDs for the tape drives). If the drive SCSI ID is:
Valid, the tape drive may be defective. Contact Customer Support.
Invalid, the SCSI sub-plate has failed and needs to be replaced (see
Replacing the SCSI Sub-Plate
).
The new tape drive is installed.
Replacing the SCSI Sub-Plate 0
To replace the SCSI sub-plate:
1 Suspend all host activity on the SCSI bus.
2 Power off the drive by setting the Drive Power option to OFF (refer to
Turning Off Drive Power
on page 4).
3 Disconnect the cables from the old SCSI sub-plate.
4 Remove the old SCSI sub-plate from the drive:
Note: Installing a new Fibre Channel tape drive will require the
Fibre Channel host or SAN to remap the tape drive.
Caution: This procedure is necessary only if you performed the
procedure in Installing the New Tape Drive Canister
, the tape
drive SCSI ID is invalid, and the host does not detect the
presence of the tape drive.
Vista de pagina 8
1 2 3 4 5 6 7 8 9 10 11 12

Comentarios a estos manuales

Sin comentarios