Quantum Tape Drive DLT VS80 Manual de usuario descargar pdf (Pagina 30)

Chapter 3: DLT VS80 Installation

3-16 May 2004 001596-01 Rev A07

6. Select a SCSI cable with an open 68-pin, high-density connector.

7. Connect one end of the SCSI cable to the SCSI connector on the rear panel of your tape drive. The

SCSI connectors are keyed, preventing improper connection.

8. Connect the other end of the SCSI cable to the SCSI host bus adapter, aligning the colored stripe

on the ribbon cable with pin 1 on the SCSI host bus adapter’s connector.

9. Locate an available power cable in the host server or workstation and attach it to the power

connector on the rear panel of the tape drive. The connectors are keyed, preventing improper

connection.

OTES:1If the SCSI cable does not fit the connector on your SCSI host

bus adapter, you either have an incompatible SCSI host bus

adapter or you need to purchase a cable adapter. Contact your

Quantum sales representative or your SCSI host bus adapter

manufacturer for information.

2 Refer to “Terminating Your Internal Tape Drive” on

page 3-12 to determine if you need to host bus adapter use an

LVD/SE terminator with the SCSI cable.

Figure 3-11. SCSI and Power Cable Location (Internal Tape Drive)

SCSI cable

(shown with

terminator

installed)

Power cable

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 49 50

Sin comentarios

Quantum Tape Drive DLT VS80 Manual de usuario Pagina 30