Quantum PX502 Guía de usuario descargar pdf (Pagina 8)

PX502 Tape Library Quick Start Guide

3 Secure the back of the library to the rack with two

mounting clamps and two Allen screws on each clamp.

The mounting clamps are oriented differently

depending on the depth of the rack (see figure 10

4 Secure the mounting clamps to the rack rails with two

PHILLIPS screws on each side (see figure 10

Figure 10 Securing the Back of

the Library

5 To install the tape drives into the library:

a Remove the tape drive cover plates (if necessary,

some libraries ship with one tape drive installed) by

loosening the captive screws securing the plate to

the library chassis (see figure 11

Figure 11 Removing the Tape

Drive Cover Plates

OTE: If the rack depth is 27 to 30 in., the long portion

of the clamp is mounted to the back. If the rack

depth is 30 to 36 in., the long portion is mounted

to the front.

Right-hand back

bracket shown.

Allen

screws

Long

portion

Cover plate

Tape

drive

bay 1

Tape drive

bay 2

b Insert the tape drive(s) into the drive bay(s) slowly

until the connectors are seated. Refer to figure 12 for

drive bay numbering (see the

Quantum PX500 Series

Tape Drive Installation Instructions

PN 81-81301 for

information).

Figure 12 Installing the Tape

Drives

c Tighten the tape drive thumbscrews using a flat

blade screwdriver.

d Repeat these steps to install another tape drive in a

different location, if desired.

The library chassis is installed in the rack.

Cabling the Library

1 Connect the SCSI cables and jumpers as shown in the

following figures:

• Figure 13 SCSI System Controller Board

• Figure 14 Surrogate SCSI System Controller Board

• Figure 15 Native Fibre Channel System Controller

Board

NOTE: Quantum ships sufficient SCSI cables and

terminators with the libraries to set up two-drives

per SCSI bus. One tape drive per SCSI bus may be

necessary for optimum performance. Refer to

your tape drive documentation.

OTE: SCSI cable lengths should not exceed:

• 39.37 feet (12 meters) between the host and

the library for single drive per bus installations.

Tape

drive 2

Tape

drive 1

Back of Library

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Comentarios a estos manuales

Sin comentarios

Quantum PX502 Guía de usuario Pagina 8

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Quantum PX502