Quantum PX720 Manual de instalación descargar pdf (Pagina 36)

Quantum PX720 Unpacking and Installation Instructions

Document 6444602-04 A01

March 2005

36 Installing the Quantum PX720 Library

Figure 34 Setup Screen

The Setup screen displays the following information:

• IP Address (requires cabinet reboot)

•IP Subnet Mask

•IP Gateway

• DHCP (default enabled)

• Change Password

• Restore Factory Settings

•Drive Autoclean

• Configured Drives

• Configured Slots

•Left Load Port (16)

• Right Load Port (32)

•Service Mode

6 To edit the setup information, use the up and down arrows to highlight

the section and press

Select.

• To set the IP address, subnet mask, and gateway, use the up and

down arrows to select the appropriate number and press

Select to

accept.

• To enable/disable DHCP, use the up and down arrows to toggle

between enable/disable. Press

Select to accept the setting. If your

library is not connected to a network which uses a DHCP server to

assign IP addresses, disable this function.

Back

Select

1 2 ... 31 32 33 34 35 36 37 38

Sin comentarios

Quantum PX720 Manual de instalación Pagina 36