Quantum DAT 24 Drive Guía de usuario descargar pdf (Pagina 61)

Commands: Locate (2Bh) Page 49

Completion Status

The Completion Status for the LOCATE command is shown in the following table.

Code Message Description

00h Good

Status

• The tape is positioned to the logical block address specified.

• The drive remains in any previously set mode.

• The drive is ready to perform any appropriate command.

02h Check

Condition

Extended Sense Byte 02h:

Code Message Description

02h Not Ready No cartridge is inserted in the drive.

04h Hardware Error Parity error on SCSI bus or drive

hardware failure detected.

05h Illegal Request

• An illegal partition number is requested.

• The CDB contains an invalid bit.

• CP bit is set when a single-partition tape is

installed.

06h Unit Attention

• The cartridge was changed prior to

accepting this command.

• The drive was reset prior to this command.

08h Blank Check The specified logical block address was not

found on tape. Tape is positioned at EOD.

That is, it is positioned after the last filemark

or set mark of the current partition. The next

WRITE command appends data to the tape.

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 180 181

Sin comentarios

Quantum DAT 24 Drive Guía de usuario Pagina 61