Quantum DAT320 Drive Guía de inicio rápido descargar pdf (Pagina 11)

Registering Your Tape Drive 11

DAT 320

2 Turn on the computer.

3 If necessary install the DAT320 O/S driver.

4 Install your backup software program. The documentation that came with your

software should describe this procedure.

5 Gently insert a tape cartridge into the tabletop tape drive’s slot. Slide the cartridge

into the slot until the drive accepts the cartridge and loads it. A brief delay occurs

while the drive identifies the cartridge type and state, and moves the tape to the

data area. Then the green Ready LED goes ON.

6 Use your backup software application to perform a sample backup-and-verify

operation. The green Ready LED flashes as data is written to and/or read from the

tape.

7 At the end of the operation, press the

Eject button on the front of the tabletop tape

drive to eject the cartridge from the drive.

Registering Your Tape Drive

After you install the tape drive, be sure to register it. Registering your drive ensures that

you will receive the latest information about your drive, as well as other product, service,

and support information. For your convenience, you can register your drive through our

Web site.

•Please visit

www.quantum.com/registration to register your product.

Safety Compliances

The DAT 320 Tape Drives are safety compliant with the following regulatory

organizations and codes in the countries indicated:

Country Regulatory Organization Compliant to:

US / CANADA Underwriters Laboratories UL

or Canadian Standards

Association CSA

UL/CSA 60950-01,

2nd Ed.

EU member nations Comité Europèen de

Normalisation

Electrotechnique – the

European Committee for

Electrotechnical

Standardization (CENELEC)

EN 60950-1

:2006+A11:2009

1 2 ... 6 7 8 9 10 11 12 13 14

Sin comentarios

Quantum DAT320 Drive Guía de inicio rápido Pagina 11