Quantum DLT 4000 Manual descargar pdf (Pagina 35)

Quantum DLT 4000 Tape Drive 2-1

Chapter 2

HARDWARE IMPLEMENTATION

This chapter describes how to install the internal tape drive or “brick” into a rackmount system. This

includes configuration jumper settings, connector pin assignments, installation instructions, power

and signal cabling descriptions, and operating instructions. This chapter also includes information

on configuring and connecting the tabletop version of the drive into a system.

This chapter covers the following topics:

• Safety, Handling and Electrostatic Discharge (ESD) Protection (Section 2.1)

describes appropriate guidelines when working with the tape drive.

• Drive Setup (Section 2.2) describes how to set up the tape drive for SCSI ID,

TERMPWR, and parity checking.

• Drive Installation (Section 2.3) describes how to mount and install the tape

drive into the system.

• Drive Connections (Section 2.4) identifies the connectors on the tape drive

including the SCSI, power and optional loader connectors.

• Drive Controls and Light Emitting Diodes (LED’s) (Section 2.5) identifies

the front panel controls and LED’s and describes their functionality. It also

explains density selection.

• Power On Self Test (POST) (Section 2.6) describes the activities that occur

when power is first applied to the drive.

• Troubleshooting (Section 2.7) lists troubleshooting tips in the event that the

tape drive fails.

2.1 SAFETY, HANDLING AND ELECTROSTATIC DISCHARGE (ESD) PROTECTION

Inappropriate or careless handling of tape drives may result in damage to the

product. Follow the precautions and directions to prevent damaging the tape

drive.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 299 300

Sin comentarios

Quantum DLT 4000 Manual Pagina 35