Quantum DLT 8000 Manual de usuario descargar pdf (Pagina 1)

GESNSO2X

Revision 10 – 6 January, 2003

TAPE DRIVE ATTACHMENT TO SUN SPARC WORKSTATIONS

(Solaris 2.4 or higher)

This application note is to be used only as a guideline for the above titled subject. It is assumed that the

user of these notes is knowledgeable on the above titled platform and associated operating system and

utilities. The user assumes all responsibility for understanding the interrelationships of this information

with other affected software or system products. Overland Data provides this information as a service

only, and assumes no responsibility for any damages which could result from the use of this information.

The information in this application note is subject to change without notice and is not to be construed as a

commitment by Overland Data. Overland Data assumes no responsibility for any errors that may appear

in this document. Brand or product names used in this document are trademarks or registered trademarks

of their respective holders.

This document describes the procedure for attaching Overland Data tape drives to the

Sun Microsystems Sparcstation family of products running under Solaris 2.4 or higher.

This Application Note should NOT be used under Solaris 2.3 or earlier releases.

1. Verify that the unit has a SCSI interface compatible with the SCSI controller installed

in the workstation (i.e., low voltage differential, single-ended or high voltage

differential).

2. Determine available SCSI IDs on the workstation. If this information is not known,

halt the Sun system and at the ok prompt type probe-scsi or probe-scsi-all

to display the addresses of devices currently connected to the system (refer to your Sun

system documentation if necessary). Each device on the SCSI bus must have a unique

SCSI ID. If necessary, refer to the appropriate User & Installation Manual for

instructions on setting the SCSI ID of the tape drive.

3. Using an appropriate text editor (like vi) edit the file /kernel/drv/st.conf.

It is important to use the exact spelling, case, and punctuation when entering the

information into the st.conf file (for example, there must be five spaces between DEC

and DLT2000 when entering the string for the DLT2000XT).

It may be helpful if the user reads the man pages on st prior to editing any files.

1 2 3 4 5 6 7

GESNSO2X 1

Indice de contenidos

Pagina 1 - GESNSO2X

GESNSO2X Revision 10 – 6 January, 2003 TAPE DRIVE ATTACHMENT TO SUN SPARC WORKSTATIONS (Solaris 2.4 or higher) This application note is to be used

Pagina 2

GESNSO2X Revision 10 – 6 January, 2003 Add the following in st.conf: tape-config-list="SEAGATE ULTRIUM06242-XXX",”Overland LTO","

Pagina 3

GESNSO2X Revision 10 – 6 January, 2003 # ls -l /dev/rmt/? A display similar to following will be shown: /dev/rmt/0 -> ../~path~/st4,0/dev/rmt/1

Pagina 4

GESNSO2X Revision 10 – 6 January, 2003 HP LTO Ultrium-1 (rewind, no BSD behavior) Device File Density Code Format Selected /dev/rmt/0l 0x00 100 G

Pagina 5

GESNSO2X Revision 10 – 6 January, 2003 AIT-1 or AIT-2 uncompressed (AIT-1 or AIT-2 cassette) /dev/rmt/0h 0x00 AIT-3 uncompressed (AIT-3 cassette) or

Pagina 6

GESNSO2X Revision 10 – 6 January, 2003 SDX-300C (rewind, no BSD behavior) Device File Density Code Format Selected /dev/rmt/0l 0x00 AIT-1 uncompr

Pagina 7

GESNSO2X Revision 10 – 6 January, 2003 DLT2000XT (rewind, no BSD behavior) Device File Density Code Format Selected /dev/rmt/0l 0x17 2.6 GB uncom

Mas documentos para Las unidades de cinta Quantum DLT 8000

a Ver el documento Quantum DLT 8000 Manual

Quantum DLT 8000 Manual (408 paginas)

a Ver el documento Quantum DLT 8000 Guía de usuario

Quantum DLT 8000 Guía de usuario (69 paginas)

Comentarios a estos manuales

Sin comentarios

Quantum DLT 8000 Manual de usuario Pagina 1

Busca en linea o descarga Manual de usuario para Las unidades de cinta Quantum DLT 8000. dlt4000 to sun2.4 & 5.4 Manual de usuario

Indice de contenidos

Mas documentos para Las unidades de cinta Quantum DLT 8000

Comentarios a estos manuales

Quantum DLT 8000 Manual de usuario Pagina 1

Busca en linea o descarga Manual de usuario para Las unidades de cinta Quantum DLT 8000. dlt4000 to sun2.4 & 5.4 Manual de usuario

Indice de contenidos

Mas documentos para Las unidades de cinta Quantum DLT 8000

Comentarios a estos manuales

Relacionado con productos y manuales para Las unidades de cinta Quantum DLT 8000