Quantum Scalar 1000 Guía de usuario descargar pdf (Pagina 21)

Internal Components 2-7

22 June 2004

• An X-Axis drive for moving the Cartridge Accessor the

length of the rails in the CM and the EMs.

• A Y-Axis drive for moving the Gripper Assembly

vertically in the CM and the EMs.

Tape Cartridges

The Scalar 1000 automates the retrieval, storage, and control

of 3590, DLT, SDLT, LTO, and AIT cartridges.

Two characters are used to identify the cartridge type. For

SDLT and LTO cartridges, the media identifier is embedded at

the end of the barcode label. Any code 39 labels are supported.

Refer to the Scalar 1000 Operator Guide for more information on

label types supported by the Scalar 1000.

Insert/Eject Station

The I/E Station allows for the insertion and ejection of

cartridges without interrupting the normal operation of the

library.

The I/E Station uses two different cartridge magazines. One

magazine has a capacity of six half-inch cartridges (3590/

DLT/SDLT/LTO), the other magazine has a capacity of nine

8 mm (AIT) cartridges. A maximum of two magazines of any

type can be present in the I/E Station at any time. If you have

two different magazines in an I/E Station, such as one half-

inch and one 8 mm magazine, the library requires Scalar DLC.

For more information on Scalar DLC, refer to Scalar DLC

Option on page 2-11 or contact an ADIC representative.

The coordinate for the rows in the old style I/E Station is

always contiguous (1 to 12 for half-inch and 1 to 18 for 8 mm).

Since two magazines of different cartridge types can be

present in the I/E station at any time, the first cell of the

bottom magazine of the new style I/E station always starts

with Row 10.

Note

Duplicate

barcode labels

(even with

different media

identifiers) are

NOT supported.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 55 56

Sin comentarios

Quantum Scalar 1000 Guía de usuario Pagina 21