Quantum DAT 160 Guía de usuario descargar pdf (Pagina 25)

Chapter 2 Installing Internal Tape Drives

Prepare Mounting Bay

Quantum DAT 160 User’s Guide 11

Prepare Mounting Bay

1 Assemble the necessary tools and materials:

• Phillips screwdriver

• Flat-bladed screwdriver (if your server uses slotted screws)

• Torx screwdriver (if your server uses torx screws)

• Your server manuals (for reference during installation)

2 Perform a normal system shutdown and turn off the server and any

connected peripherals.

3 Remove the cover and front panel from the server, as detailed in your

server’s documentation.

As you work inside the server, you may have to disconnect other

signal cables or power cables from other devices to maneuver the

new drive into place. If you have to do this, make a note of their

position and connections so you can put them back correctly later.

Figure 4 Removing Cover from

Server

4 You are now ready to install your tape drive.

Caution: To avoid personal injury or damage to the server or tape

drive, ensure that the server is disconnected from the

main

power supply while you install the drive.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 81 82

Sin comentarios

Quantum DAT 160 Guía de usuario Pagina 25