Quantum DAT 160 Guía de usuario descargar pdf (Pagina 42)

Chapter 3 Installing External Tape Drives

Connecting the SCSI Tape Drive

Quantum DAT 160 User’s Guide 28

• If you do not need to change these default settings, proceed to

hecking SCSI Termination.

Table 5 External Tape Drive

Default Settings

An external Quantum DAT 160 drive will operate using any voltage in

the range 100–240 volts (0.7 A, 50-60 Hz). No adjustment is needed.

Check the Drive’s SCSI

ID 3

Your Quantum DAT 160 drive is shipped with a default SCSI ID of 3.

Each device on the SCSI bus must have an unique SCSI ID number. The

drive can be assigned any unused ID between 0 and 15. Do not use SCSI

ID 7, which is reserved for the SCSI controller. SCSI ID 0 is typically

assigned to the boot disk and should also not be used unless the tape

drive is on a dedicated SCSI bus.

Parameter Default Setting

SCSI ID 3

SCSI controller 7

Host operating system Microsoft 2000, 2003, XP Professional, and

Linux Kernels 2.6 or higher

Note: The drive can be assigned any unused ID between 0 and 15.

Do not use SCSI ID 7, which is reserved for the SCSI controller.

SCSI ID 0 is typically assigned to the boot disk and should not

be used unless the tape drive is on a dedicated SCSI bus.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 81 82

Sin comentarios

Quantum DAT 160 Guía de usuario Pagina 42