Quantum Qflash X4d Instrucciones de operaciones descargar pdf (Pagina 14)

When using a Telephoto Reflector QF63B the Auto mode cannot be used

because the flash sensor is blocked. Use Manual, TTL, QTTL, Strobo or

Linked modes.

Use “B” series reflectors (QF61B, QF62B g/s, QF63B) with Qflash 4d. The

standard QF60 reflector mounts to Qflash 4d as well.

5.9.7 Changing between Feet and Meters

Set your preference for the display of metric (M) or US distance (Ft) units.

Guide numbers also change accordingly.

5.10 Features of Qflash

5.10.1 Flash Ready

One beep will sound

(if the speaker P is ON)

when Qflash finishes

recycling.

5.10.2 Display, Speaker, and Indicator Lights

Qflash indicates the result of a flash exposure on the Display, via Speaker

(if turned on, Section 5.9.4) or by Flash Indicator Lights (if turned on,

Section 5.9.5). The signals are shown in the table below:

5.10.3 Auto mode exposure indications

There are three types of exposure indications. The display will blink either

OK, Over, or Undr. The display will also indicate how much over or under

the exposure was, from +3 stops to -3 stops. If an arrow appears then the

exposure error is more than 3 stops (for example 3)

Flash exposure condition Display Speaker/Earphone Flash Indicator Lights

Good exposure OK one beep rapid blink

Under/Over Under or Over 3”beeps 3 blinks, pause,

3 blinks, pause...

No flash No Flash long steady beep long steady on

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 43 44

Sin comentarios

Quantum Qflash X4d Instrucciones de operaciones Pagina 14