Quantum Qflash X4d Instrucciones de operaciones descargar pdf (Pagina 28)

If the Control Qflash is in Auto mode, then Linked mode may appear

for R1 or R2 modes. Next to Linked will appear the ratio. Use the

Up/Down JLbuttons to change this ratio. (If both R1 and R2 are in

‘Linked’ or TTL mode, the ratio will appear next to R1 only, although this

ratio is for both flashes).

Press Set G again and the word SEND will appear next to the data for R1

or R2. The Control Qflash in now sending the data to the Remote Qflash.

8.1.3 Confirmation of data sent to Remote Qflashes

Once data is sent, the Remote Qflash sends back a confirmation signal to

the Control Qflash. If the confirmation signal is received then the data for

the Remote Qflash will remain on the display. If the confirmation signal is

not received then the data will be replaced by a series of dashes. The lat-

ter case will result when only one Remote Qflash is active (or if the radio

link is lost).

Qflash Remote screen before

changed on Control Unit.

Screen after confirmation

Qflash cannot fire while sending or receiving data from Wireless

Remote units or when the display is blinking.

To speed up the exchange, press Set G on the Control Qflash until SEND

appears in the display. When SEND disappears, Qflash is ready.

If a shot is attempted and Qflash is not ready, two beeps will sound, and

lights will blink twice, repeatedly (if the flash indicators are activated in

Options).

8.1.4 Wireless Control with QTTL adapters

When the Control Qflash is connected to the camera with a D series QTTL

adapter additional features become available:

The camera settings for F# and ISO will appear on the Control Qflash dis-

play. Generally, to update the camera settings, press the camera shutter

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 43 44

Sin comentarios

Quantum Qflash X4d Instrucciones de operaciones Pagina 28