Quantum LTO-2 Manual de usuario descargar pdf (Pagina 36)

Chapter 3 Operation

Using LTO Cartridges

22 LTO-2 Half-Height Tape Drive User’s Guide

Using LTO Cartridges 3

Loading a

Cartridge

To load an Ultrium cartridge into the LTO-2 Half-Height Tape Drive,

place the cartridge in the slot and then do one of the following:

• Continue to push the cartridge the rest of the way into the drive.

•Press the

load/unload button on the front of the drive to seat the

cartridge.

• Use a library or host command to finish loading the tape.

Unloading a

Cartridge

To unload an Ultrium cartridge from the LTO-2 Half-Height Tape Drive,

either:

• Use a library or host command to unload the tape, or

•Push the

load/unload button on the front of the drive.

Write-protecting a

Cartridge

Ultrium cartridges have a sliding write-protect switch near the back right

corner of the cartridge, see figure 9

• If you slide the switch toward the center of the cartridge, data can be

read from the cartridge but not written to it.

Note:

•

ON refers to a constant light

•

Slow refers to a blink rate of 1/2 second on, 1/2 second off

•

Fast refers to a blink rate of 1/8 second on, 1/8 second off.

Caution: Several seconds may elapse between the time you press

the

load/unload button and the time the cartridge is

ejected. Do not power down the tape drive or the host

computer until the drive has completely ejected the

cartridge.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 93 94

Sin comentarios

Quantum LTO-2 Manual de usuario Pagina 36