
Appendix B Setup CD and Setup Menu
Reinstalling the Controller Operating System
114 Quantum DX-Series User’s Guide
Figure 70 Connecting
the Service PC to the
Controller
Serial port
DX30 shown
2 Open a terminal emulation program on your host system and set the
following properties:
• Baud rate 115200
• Data bits 8
• Parity none
•Stop bits 1
• Flow control none
•Emulation ANSI
Installing System
Firmware
2
To install the system firmware (Linux operating system):
1 Insert the setup CD in the controller CD-ROM drive.
2 Reboot the controller by pressing the reset button on the front of the
controller.
The controller reboots. The terminal emulation session displays the
boot process on the controller. When the boot process completes, the
following menu displays (see
figure 71).
Comentarios a estos manuales