Quantum DPA Guía de usuario descargar pdf (Pagina 36)

Installing the CP 3100 Installing a Desktop CP 3100

Figure 19. Back Panel of the Desktop CP 3100

Connecting to a Host

To connect the desktop CP 3100 to a host computer, use the following procedure.

1. Shut down the host computer and disconnect the computer’s AC power cord.

2. Connect an LVD Male HD68 SCSI cable to the SCSI IN connector on the back panel of the

desktop CP 3100 (see

Figure 19 on page 37).

3. Connect the other end of the cable to the computer.

Connecting to a Tape Drive

If you purchased the CP3100D-160, connect the unit to an approved DDS-4 or DAT 72 tape archive

device.

1. Connect an LVD Male HD68 SCSI cable to the ARCHIVE SCSI connector on the back panel

of the desktop CP 3100 (see

Figure 19 on page 37).

2. Connect the other end of the cable to your tape drive.

NOTE. The following connectors on the back panel of the desktop CP 3100 are not used:

• Archive Network (Gbe2)

• Serial

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 100 101

Sin comentarios

Quantum DPA Guía de usuario Pagina 36