
Chapter 2 Basic Library Operations
Using the GUI
Quantum P4000 and P7000 Libraries User’s Guide 43
3 Verify that the CHM is empty by checking the Overview screen on the
GUI (see Chapter 3, Operator Commands
).
If there is a tape cartridge in the CHM, perform a
Move command to
place the cartridge in an available bin.
4 Turn off the power switch located below the GUI.
Using the GUI 2
The GUI is activated by touching the screen, and is located on the front of
the library. The menus on the GUI allow you to obtain information about
the library, execute library commands, and test library functions (see
figure 24
).
The GUI’s functions are grouped into the following four screens:
•
Overview screen—displays current tape drive, CHM, and load port
content and activities.
•
Tapes screen—displays tape drive, storage bin, load port, and gripper
inventories.
•
Operator screen—contains library configuration and control functions
(password protected).
•
Service screen—contains reporting functions, system tests, and
service commands (password protected).
Note: Wait ten seconds before turning on the power switch
again.
Comentarios a estos manuales