Quantum LTO 1 Información técnica descargar pdf (Pagina 4)

4 Installing the Internal LTO-3 Half-Height Tape Drive

LTO-3 Half-Height Tape Drive Quick Start Guide

2 Connecting the Internal Drive Interface and DC Power Cables on page 8

3 R

estarting the Internal Tape Drive System on page 9

4 I

nstalling the LTO Driver Software on page 13, if required

5 Registering the LTO-3 Half-Height Tape Drive

on page 13

Configuring the Internal

Parallel SCSI Tape Drive 0

The factory-set default configuration of the internal parallel SCSI LTO-3 Half-Height Tape

Drive is:

• SCSI ID: 6

• Terminator power: enabled

Configuring the Internal Drive Parallel SCSI ID

Each device on the parallel SCSI bus must have its own unique SCSI ID. Use SCSI

configuration jumper pins 1–2, 3–4, 5–6, and 7–8 on the drive back panel to change the

SCSI ID of the LTO-3 Half-Height Tape Drive (see figure 2

serial-attached SCSI (SAS), there is no need to configure the SCSI ID or bus

termination, as SAS is a point-to-point architecture.

Skip to Mounting the Internal Tape Drive on page 6

IF the default parallel SCSI ID

configuration is . . .

THEN you can . . .

compatible with your system

SCSI bus,

skip the following subsection and proceed to

Configuring the Internal Parallel SCSI Terminator

Power on page 5.

already assigned to another

device,

change the configuration of either the other

device, or the LTO-3 Half-Height Tape Drive, as

described in the following subsection.

IF the drive interface is . . . THEN . . .

1 2 3 4 5 6 7 8 9 ... 15 16

Sin comentarios

Quantum LTO 1 Información técnica Pagina 4