Quantum DAT 432/864 Loader Guía de usuario descargar pdf (Pagina 25)

Installing the Autoloaders Installing the Internal Autoloader

Figure 6. Locations of Mounting Holes

Connecting the SCSI Interface Cable

Turn off all power to your computer and drive. Then connect a 68-pin wide internal SCSI cable from

your SCSI controller to the SCSI connector on the back of the autoloader. Be sure pin 1 on the SCSI

controller and cable is connected to pin 1 on the drive. Figure 7 on page 26 shows the location of

SCSI pin 1 on the drive’s SCSI connector. Pin 1 on the SCSI cable should be indicated by a colored

stripe.

The internal autoloader drive can be used with two types of SCSI interfaces:

• Ultra2 SCSI (LVD)

• “Wide” (16-bit) single-ended SCSI

The drive can automatically detect whether it is connected to an LVD or single-ended wide SCSI bus.

NOTE: The internal autoloader will not operate properly in a SCSI-1 environment.

MOUNT HOLE

M3 (4 PLACES)

± 0.25

1.8

± 0.25

7.0

± 0.3

45.5

± 0.25

203.2

± 0.25

79.5

± 0.25

11.9

± 0.3

82.6

± 0.6

21.8

± 0.3

45.5

± 0.25

M3 (4 PLACES)

MOUNTING HOLE

149.6

± 0.25

203.2

± 0.5

79.5

± 0.25

139.7

± 0.3

146 +1

.5 –0.5

1.8

± 0.25

224.0 max

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 58 59

Comentarios a estos manuales

Sin comentarios

Quantum DAT 432/864 Loader Guía de usuario Pagina 25

Comentarios a estos manuales

Relacionado con productos y manuales para Las unidades de cinta Quantum DAT 432/864 Loader