Quantum DAT 432/864 Loader Guía de usuario Pagina 48

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 59
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 47
Configuration for Novell and UNIX Operating System Configuration
48
Solaris 2.x
1. To configure Solaris 2.x for compatibility with the DAT 72 or DDS-4, add the following lines to
the file st.conf in the directory /kernel/drv.
tape-config-list=
“ARCHIVE Python”,“Iomega DAT Drive”,“ARCHIVE Python DAT”;
ARCHIVE Python DAT = 1,0x34,0,0xd639,4,0x00,0x8C,0x8C,0x8C,3;
2. After modifying the file st.conf, you must reconfigure the kernel by booting the system using
the boot -r command.
Configuration for SGI Environment
DIP Switch Settings
Before using the DAT 72 or DDS-4 autoloader in a SGI UNIX environment, ensure that the DIP
switches are set as shown in the following table:
Irix V5.x
To configure Irix 5.x to use the DAT 72 and DDS-4 autoloader, you must modify the file /var/
sysgen/master.d/scsi as described below:
1. Edit the file /var/sysgen/master.d/scsi and add the following entry:
{DATTAPE,TPDAT,7,3, “ARCHIVE
Python",“DAT"/*DAT*/,0,0,{0,0,0,0},
MTCAN_BSF|MTCAN_BSR|MTCAN_APPEND|MTCAN_SETMK|MTCAN_PART|MTCAN_
PREV|
MTCAN_SYNC|MTCAN_SPEOD|MTCAN_CHKRDY|MTCAN_VAR|MTCAN_SETSZ|
MTCAN_SILI|MTCAN_SEEK|MTCAN_CHTYPEANY,
/* minimum delay on i/o is 12 minutes, to allow the Drives
* full error recovery sequence to be performed. */
40, 12*60, 12*60, 12*60, 512, 512*512 }
2. Rebuild the kernel using the autoconfig command (see the autoconfig man page for
details). After the kernel is rebuilt you will need to reboot the system again to bring the
changes into effect.
Switch
5
Switch
6
Switch
7
Switch
8
Switch
10
Setting ON ON ON ON OFF
NOTE: The main difference between tape autoloader support in Irix 5.x and 6.x is the
introduction of Data Compression switching via software in Irix version 6.2. When running Irix
5.x, the autoloader will operate in the compression setting determined by switches 1 and 2,
accessible through a removable panel on the bottom of the autoloader.
NOTE: Irix 5.3 and later will detect the changes made and automatically rebuild the kernel the
next time the system boots.
Vista de pagina 47
1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 58 59

Comentarios a estos manuales

Sin comentarios