Quantum DLT 2500 Manual de servicio descargar pdf (Pagina 36)

Chapter 2: Installing the Sled-Mounted DLT2000XT Tape Drive

4. Place two of the jumpers on the H2 middle pins (as seen from the top), as shown in

Figure 2-9.

Installing the Tape Drive

Note:

Be sure you have read and understood the information in “Checking and Setting

the Drive’s SCSI ID” before you install the DLT2000XT tape drive in your rack system.

This procedure requires a short-shaft #2 Phillips-head screwdriver.

Conﬁgure your Challenge or Onyx SCSIBox 2 for the DLT2000XT tape drive by following

these steps:

1. Open the lower front door of the chassis and ensure that the system is powered off.

2. Open the door to the SCSIBox 2 by releasing the two wing nuts, as shown in

Figure 2-10.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 113 114

Sin comentarios

Quantum DLT 2500 Manual de servicio Pagina 36