Quantum DLT 2500 Manual de servicio descargar pdf (Pagina 40)

Chapter 2: Installing the Sled-Mounted DLT2000XT Tape Drive

7. Select a vacant drive bay and carefully align the rails on the drive sled with the

corresponding rails in the drive bay.

8. Slide the DLT2000XT tape drive into the bay until the locking mechanism is

engaged and the locking lever on the drive sled moves down to the locked position.

Push the lever down to ensure that it is fully engaged.

9. Close the SCSIBox 2 door and secure the captive wing nuts.

10. Power on the system.

11. Close the lower front access door of the system chassis.

For additional system software conﬁguration information, refer to IRIX Admin: Peripheral

Devices.

Installing the DLT2000XT Tape Drive in a Vault Rack

The SCSIBox 2 drive box that installs in the Vault Rack is available in two different

conﬁgurations, single-ended and differential. You must have the single-ended version of

the SCSIBox 2 installed in your Vault Rack if you wish to use a sled-mounted DLT2000XT

tape drive in the box.

Caution: If you do not know what type of drive box you have, do not install the

DLT2000XT tape drive into the box. Consult with your system administrator or service

provider before going ahead with the installation. Installing a single-ended DLT2000XT

tape drive in a differential SCSIBox 2 causes SCSI bus errors and failure.

Note: Be sure you read and understand the information in “Checking and Setting the

Drive’s SCSI ID” before you install the DLT2000XT tape drive in your Vault Rack.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 113 114

Sin comentarios

Quantum DLT 2500 Manual de servicio Pagina 40