Quantum DLT-V4 Manual de usuario descargar pdf (Pagina 19)

Chapter 1 Physical Specifications

Internal Tape Drive Mounting Hole Dimensions

DLT-V4 Product Specification 5

Figure 1 Internal Tape Drive

Mounting Hole Dimensions

(Bottom View)

Figure 2 shows the mounting holes and dimensions in a side view for the

internal tape drive.

Notes: The following is additional information for figure 1.

• The dimension referenced in boxed note [1] is from the front of the base plate.

• The dimension referenced in boxed note [2] is from the right-side tape drive mounting plane to the

interior guiding surface of the media opening.

• The dimension referenced in boxed note [3] is from the bottom tape drive mounting hole to the

interior guiding surface of the media opening.

• The tape drive width and length are standard 5¼-inch form factor measurements.

• Dimensions are identical on left side and right sides.

• Dimensions are in millimeters. The dimensions in brackets [x.x] are in inches.

Data cartridge

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 61 62

Sin comentarios

Quantum DLT-V4 Manual de usuario Pagina 19