Quantum ACL 452 Guía de instalación descargar pdf (Pagina 34)

Chapter 2 Unpacking the Library

Packing the Library for Shipment

18 ACL 4/52 Facilities Planning and Installation Guide

Unloading the Library

To unload the library:

1 Remove all tapes from the fixed storage bins.

To do this, grasp the exposed end of each tape and lift it out of the

bin.

2 Remove any tapes in the load port bins.

Load port bins are accessible from inside the library. To remove a

tape from the load port, grasp the exposed end and lift it out.

3 Remove any ejected tapes from the tape drives.

4 If you ejected any tapes prior to turning off the library, they may be

in the drive slots. Remove each tape carefully from the drive; make

sure the tape is completely unloaded (not buckled to the take-up

leader) before completely removing it.

5 For more information, refer to the ACL 4/52 Operator’s Guide.

Installing the Internal

Packing Materials

To install the packing materials:

1 Install the foam blocks as shown in figure 12 on page 14 and

explained below:

a Gently raise the vertical carriage and place the vertical carriage

foam block into position. Lower the vertical carriage onto the

foam block.

b Install both the top and bottom horizontal carriage foam

blocks.

c Gently slide the horizontal carriage toward the back of the

library and against the horizontal carriage foam blocks.

2 Install four tie-wraps to secure the extension axis, the vertical

carriage, and the horizontal carriage as shown in figure 11 on

page 13 and explained below:

a Route the two horizontal carriage tie-wraps through the notch

on the vertical rail and secure them through the notch on the

frame.

b Route the extension axis tie-wrap around and back up through

the extension axis platform and secure it around the gripper

motor.

Note:

Do not route the tie-wrap over the gripper motor power cable.

c Route the vertical axis tie-wrap under the bumper standoff and

secure it around the extension axis platform.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 67 68

Sin comentarios

Quantum ACL 452 Guía de instalación Pagina 34