Quantum ACL 452 Guía de instalación descargar pdf (Pagina 41)

Chapter 3 Installing the Library

Setting Up and Testing the Library

ACL 4/52 Facilities Planning and Installation Guide 25

• Auto clean (enable/disable)

• Retries (enable/disable)

• Exabyte emulation (enable/disable)

• Read barcode labels (yes/no)

• Auto inventory (yes/no)

• Auto load (enable/disable)

These procedures require operator- or service-level security clearance

at the library control panel. For a description of these procedures, refer

to the ACL 4/52 Operator’s Guide.

Performing a System

Test

The system test checks out the functionality of all library components.

To run the system test, you must have Service-level access at the

control panel.

Performing an

Inventory

The inventory command identifies tape cartridges by reading their bar

code labels and writes their location to nonvolatile RAM. To run the

inventory command, you must have either Operator- or Service-level

access at the control panel.

For more information about this command, refer to the ACL 4/52

Operator’s Guide.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 67 68

Sin comentarios

Quantum ACL 452 Guía de instalación Pagina 41