Quantum Scalar i500 Guía de usuario Pagina 399

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 570
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 398
Chapter 12 Installing, Removing, and Replacing
Replacing the Control Module
Scalar i500 User’s Guide 380
6 Open the module’s access door and raise the guide pin by pulling it
up and turning it slightly as if it were a screw. Otherwise, the guide
pin may scratch the front doors of the module beneath it.
7 Slide the entire module toward you and lift it off of the module below
it.
Replacing the Control
Module 12
1 If not already removed, remove the tape drives and power supplies
from the control module you are replacing.
2 Using the Phillips #2 screwdriver (for the top cover plate) and the
T10 TORX screwdriver (for the bottom cover plate), remove the new
control module plates from the top and bottom of the module, as
necessary.
1 Guide pin
2 Thumbscrew
Vista de pagina 398
1 2 ... 394 395 396 397 398 399 400 401 402 403 404 ... 569 570

Comentarios a estos manuales

Sin comentarios