Quantum Scalar i500 Guía de usuario Pagina 494

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 570
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 493
Chapter 12 Installing, Removing, and Replacing
Tape Drive Ethernet Connectivity and the Ethernet Expansion Blade
Scalar i500 User’s Guide 475
5 Click the Cycle button corresponding to the Ethernet Expansion
blade you want to power cycle.
It takes approximately 1 minute to power cycle an Ethernet
Expansion blade. The status displays as “Booting” during the power
cycle.
Viewing Ethernet
Connectivity 12
There are two places on the library Web client which tell you whether
tape drives are connected via Ethernet (either via an Ethernet Expansion
blade or connected directly to the library control blade). These two places
are:
Tools > Drive Operations > Update tape drive firmware using a
firmware image file
Tools > Drive Operations > Retrieve Tape Drive Log
The tape drive table in each of these screens has a column called Ethernet
Connected. If the tape drive is connected via Ethernet, the tape drive IP
address will be listed in the column. If the tape drive is Ethernet capable
but not connected, the column displays “No.” If the tape drive is not
Ethernet capable, the column displays “N/A.”
You can also view the location coordinates and Ethernet Expansion blade
status in the library System Information Report:
Reports > System Information
Ethernet Expansion
Blade Status LEDs 12
The status LEDs for the Ethernet Expansion blade are located at the
bottom of the Ethernet Expansion blade below ETH 6 (see Figure 69
on
page 476).
Vista de pagina 493
1 2 ... 489 490 491 492 493 494 495 496 497 498 499 ... 569 570

Comentarios a estos manuales

Sin comentarios