Quantum PX502 Guía de usuario descargar pdf (Pagina 13)

PX502 Tape Library Quick Start Guide

Multiple Library Stacks 0

If the library will be installed in a rack with other PX500

Series libraries, you must prepare each chassis prior to

installation. Preparing the library chassis for installation into

a multiple library stack consists of:

• Removing the FlexLink cover plates

• Installing the alignment hardware

To prepare the library chassis for multiple stack operation:

1 Remove two PHILLIPS screws securing each FlexLink

cover located on the top and bottom of the library

using a #1 PHILLIPS screwdriver (see figure 23

OTE: If the library is NOT being installed with other

libraries to operate in a multiple library stack, it is

not necessary to complete the following

instructions.

OTE: It is recommended to place the Master library in

the middle of the library stack for improved

performance.

NOTE: Remove the bottom FlexLink cover on every library

except the bottom library in the stack. Remove

the top FlexLink cover on the bottom library in the

stack.

Figure 23 Removing the FlexLink

Cover

2 The alignment hardware installed on the top and

bottom of the libraries in a multiple stack allow the

FlexLink bays to align correctly when installed in a rack.

Install the following alignment hardware (see

figure 24

a Install the top alignment hardware with two Allen

head screws.

b Install the bottom alignment hardware with one

Allen head screw.

OTE: Install only the bottom alignment hardware on

the top library in the stack and the top alignment

hardware on the bottom library in the stack.

Screws

FlexLink cover

Remove only the top

FlexLink cover on the

bottom library in the

stack

FlexLink cover

Screws

Remove only the

bottom FlexLink

cover on the top

library in the stack

1 2 ... 8 9 10 11 12 13 14

Comentarios a estos manuales

Sin comentarios

Quantum PX502 Guía de usuario Pagina 13

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Quantum PX502