Quantum Vision Guía de inicio rápido descargar pdf (Pagina 23)

Updating Quantum Vision 23

Quantum Vision

19 When the IP address has been picked up by the system, you can find the IP address

by clicking the vSphere Client Summary tab and then locating the IP Address in the

right panel (see

Figure 27).

Figure 27 Locating Your

Appliance’s IP Address

For enhanced stability, it is recommended that you replace your DHCP assigned IP

address with a static IP address (A

ccessing the Console Command Line (virtual appliance

only) on page 33).

Note: For a Vision appliance, if you need to change your network ports, log on to the

Vision Console Command Line (see

Accessing the Console Command Line

(virtual appliance only) on page 33), and run the net ports command.The net

ports command opens the firewall and updates the ports.

Continue with Quantum Vision Setup on page 30.

Updating Quantum Vision

This sections presents procedures for updating the Quantum Vision Appliance and the

Quantum Vision server that was installed using the standard installer.

•

Updating the Virtual Appliance

• Updating Quantum Vision 4.2.0 virtual appliance to 4.3.2

•

Updating Quantum Vision 4.2.1 virtual appliance to 4.3.2

•

Updating Quantum Vision 4.3 or 4.3.1 virtual appliance to 4.3.2

• Updating the Standard Installer Version of Vision

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 37 38

Sin comentarios

Quantum Vision Guía de inicio rápido Pagina 23