Quantum Vision Guía de inicio rápido descargar pdf (Pagina 5)

Installing Quantum Vision 5

Quantum Vision

• Scalar i6000 library

• Scalar i2000 library

• Scalar i500 library

• Scalar i80 library

• Scalar i40 library

•Scalar LTFS

• vmPRO 4000 (software/hardware backup solution)

•vmPRO virtual backup system

Installing Quantum Vision

If Quantum Vision 3 is installed on the Vision server, you should uninstall it before you

install any version of Quantum Vision 4.

Caution: Installing Vision 4 does not upgrade an existing Vision 3 installation. It is

possible to run both Quantum Vision 3 and Quantum Vision 4

simultaneously on the Vision server. However, this is not the recommended

configuration. For more information about moving from Vision 3 to Vision

4, see the Appendix “Vision Deployment Options” in the

Quantum Vision

User’s Guide

To install the Quantum Vision software, follow the procedure for the operating system

running on the Vision server:

• Windows Installation on page 6

• Linux Installation on page 9

To update an existing installation of Quantum Vision 4 to the latest version, see

Updating

the Standard Installer Version of Vision on page 28.

Note: Before installing Quantum Vision, make sure the operating system on the

Vision server is accessible on the network. For best results, Quantum

recommends configuring the Vision server with a static IP address.

Vision 4.3.2 is also available as a VMware appliance in a format that installs within a

vSphere infrastructure. To install Vision as a virtual appliance, see V

irtual Appliance

Installation on page 12

Note: There is no technical advantage for Vision to be installed on a VM or physical

server. Vision may be installed on either a physical server or as a virtual machine

(by OVF or other means) to allow you to comply with your IT standards and

policies.

1 2 3 4 5 6 7 8 9 10 ... 37 38

Sin comentarios

Quantum Vision Guía de inicio rápido Pagina 5