Quantum Vision Guía de inicio rápido descargar pdf (Pagina 35)

Quantum Vision Setup 35

Quantum Vision

admin backup - This command prompts the user for the server name, the username

and password, and the location in which the database will be archived (on the

server).

admin restore - This command prompts the user for the server name, the username

and password, and the location in which the database is archived. The command

then copies the archive from the server to the appliance, extracts it, and then

restarts the Vision server.

net

The net commands allow the user to choose how IP addresses are assigned and to set

the http ports.

net config [dhcp|static] - The dhcp option allows the user to have DHCP assign IP

addresses. The static option allows the user to manually assign the IP address,

NetMask, and Gateway IP addresses.

net ports - This command allows the user to set the http and https ports.

net dns - This command allows the user to set IP addresses for DNS servers for the

appliance. Enter the DNS server IP address, one at a time, in priority order. Press

<enter> without an IP address when finished.

system

The system commands allow the user to reboot or shutdown the system, restart the

service, or upgrade the appliance.

system reboot - This command allows the user to reboot the system.

system restart service - This command allows the user to restart the service.

system shutdown - This command allows the user to shutdown the system.

system upgrade - This command allows the user to upgrade the Vision appliance

from the Quantum repository. With the repository-based upgrade, the system

upgrade command takes care of locating and downloading the upgrade rpm.

Note: If you are currently running Vision 4.2 or 4.2.1, you will not have access to

the Quantum repository. You will need to use either system upgrade http

or system upgrade scp to perform your upgrade to 4.3.2. When you are

running Vision 4.3 or newer, you will then have access to the Quantum

repository.

system upgrade [scp|http] - This command allows the user to upgrade the version

of Vision running on the appliance.

exit

The exit commands allow the user to exit and log off from the console command line

application.

1 2 ... 30 31 32 33 34 35 36 37 38

Sin comentarios

Quantum Vision Guía de inicio rápido Pagina 35