
Pathlight VX User’s Guide 143
HTTP Proxy Settings
When using a VPN or HTTP proxy connection to access the Pathlight VX User Interface, Internet Explorer
only works properly if the HTTP proxy settings are correctly enabled.
Use this procedure to enable the HTTP1.x proxy settings.
1 On the Windows Start menu, select Settings→ Control Panel→ Internet Options.
The Internet Options window appears.
2 Click the Advanced Tab.
3 Scroll down the list to HTTP 1.x Settings.
4 Verify that Use HTTP 1.x is selected.
5 Verify that Use HTTP 1.x through proxy connections is selected.
Supported Browser Versions
The Pathlight VX User Interface supports these Internet browsers:
• Internet Explorer 5.5 and later versions
• Netscape 7.x
Internet Explorer
Use this procedure to determine the Internet Explorer version.
1 Launch Internet Explorer.
2 On the menu bar, select Help→ About Internet Explorer.
The About window appears.
3 Under the Internet Explorer logo, locate the version number.
4 If the version number is lower than 5.5, upgrade to version 5.5 or 6.0.
Netscape Navigator
Use this procedure to determine the Netscape Navigator version.
1 Launch Netscape Navigator.
2 On the menu bar, select Help→ About Netscape.
The About information appears.
3 Locate the version number at the top of the page.
4 If the version number is lower than 7.0, upgrade to Version 7.0 or higher.
Note
For best results when using an Internet browser to access the Pathlight VX
Service and User Interfaces, verify these settings:
• JavaScript (active scripting) is enabled in the Security settings of the browser.
• Pop-up blocker is disabled.
• Page caching is disabled.
Note
If you are logged on the Pathlight VX User Interface using multiple Netscape 7.1
windows on the same laptop or PC and you log off any one of them, Netscape
7.1 may terminate the other sessions. It does not make any difference if you are
logged on the same Pathlight VX or different Pathlight VX systems.
Comentarios a estos manuales