Quantum Pathlight VX Guía de usuario Pagina 15

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 190
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 14
Pathlight VX User’s Guide 9
RAID Storage Disk
The Pathlight VX uses high-speed, low-cost AX100SC (SATA) or CX300 (ATA) RAID as its storage disk.
The storage disk is presented as a RAID. When data is processed in the Pathlight VX, it is sent from the
backup application to the SNC, assigned to a virtual library and virtual tape, and then written to the RAID
storage disk.
AX100SC - The Pathlight VX-450 uses 2 AX100SC enclosures as the RAID component. Figure 5
shows the front of an AX100SC disk enclosure and identifies its LEDs. For more information about
these LEDs, refer to AX100SC LEDs
on page 161.
Figure 5 AX100SC - front view
DPE - The Pathlight VX-650 uses CX300 enclosures as the RAID component. The CX300 is
referred to as the disk processor enclosure (DPE). Each DPE is tandemed with a standby power
supply (SPS), and cabled to up to 3 disk array enclosures (DAEs). Depending on the configuration,
the Pathlight VX contains up to 4 DPEs, an equivalent number of SPSs, and up to 12 DAEs. Figure
6 shows the front of a DPE and identifies its LEDs. Figure 7 on 10 and Figure 8 on 10 show the front
and rear views of an SPS. Figure 9
on 10 shows the front of a DAE and identifies its LEDs. For more
information about DPE and DAE LEDs, refer to DPE/DAE LEDs
on page 163. For more information
about SPS LEDs, refer to SPS LEDs
on page 168.
Figure 6 DPE - front view
Disk activity LEDs
Fault LED
Disk activity LEDs
Fault LED
Enclosure fault LED
Enclosure power LED
Disk activity LED
Disk fault LED
Vista de pagina 14
1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 189 190

Comentarios a estos manuales

Sin comentarios