Quantum FastStor 2 Guía de usuario descargar pdf (Pagina 36)

36 6-00515-03 Rev A

6. When tape drive cleaning is complete, the Clean Drive LED indicator turns off (if previously on)

and the autoloader unloads and exports the cleaning cartridge. Remove the cleaning cartridge,

and press ENTER when the LCD screen prompts you to do so.

7. If you had to remove a data cartridge to import the cleaning cartridge, import the tape to its

original slot. See

Importing Cartridges for more information.

Re-Inventory of Cartridges

This option analyzes the slots and drives in the autoloader.

To update the inventory information

1. From the Home Screen or main menu, press + or – until Commands appears on the top line

of the LCD screen.

2. Press ENTER to access the available options.

3. Press + or – until the Re-inventory message appears on the LCD screen.

4. Press ENTER.

The autoloader then checks the drive and each cartridge slot for the presence of a tape in order

to update the inventory information.

CAUTION:

If the cartridge is not a valid cleaning cartridge, the LCD screen

will display the Invalid Tape message and the cartridge will be

exported.

NOTE:

If the Clean Drive or Media Attention LED indicators illuminate when you

insert another cartridge immediately after cleaning, then see Table 7-1

Troubleshooting and Diagnostics

NOTE:

This command is only needed if the inventory in the autoloader is different than

the inventory displayed on the operator panel.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 67 68

Sin comentarios

Quantum FastStor 2 Guía de usuario Pagina 36