Quantum P3000 Guía de usuario Pagina 121

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 146
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 120
Appendix C Automatic Drive Cleaning
Reporting of Cleaning Mode
Quantum|ATL P3000 Series User’s Guide 101
GUI
3
To change automatic cleaning mode from the touch screen GUI,
select
Configuration/Auto Clean
:
Enable
- turns automatic cleaning mode on
Disable
- turns automatic cleaning mode off
Mode Select
Command
3
To change the automatic cleaning mode using the Mode Select
command set the Vendor Unique Page (20h) byte 2, bit 1 (AC) to:
One - enable automatic cleaning
Zero - disable automatic cleaning
To save the automatic drive cleaning mode setting in NVRAM set
the Mode Select command Save Page (SP) bit to one.
When the automatic drive cleaning mode setting is saved in
NVRAM, neither a SCSI bus reset or a power cycle of the Product
Name will change the mode setting.
Reporting of Cleaning Mode
3
The current drive cleaning mode can be reported by:
•Diagnostic Software
Mode Sense command
Diagnostic
Software
3
To display the current drive cleaning mode from diagnostic
software select:
Config/Report Clean Tape
The diagnostic screen will display the:
Current cleaning mode
Bar code label of each cleaning cartridge
Vista de pagina 120
1 2 ... 116 117 118 119 120 121 122 123 124 125 126 ... 145 146

Comentarios a estos manuales

Sin comentarios