
Chapter 3 Operator Commands
Configuring the Library
Quantum|ATL P3000 Series User’s Guide 45
Figure 23 Operator
Screen
Configuring the Library
3
The Configure Library command allows you to assign the
following:
• Library model number
• Number of storage bins
• Number of drives
• Library SCSI ID
• Tape drive SCSI ID
To configure any of these attributes use the following procedure.
1
In the Operator screen, press the Configure Library button.
The Configure: Library screen is displayed (see figure 24
).
Control
System
Off-line
Standby
Load Port
Overview Tapes Operator
Back Forward
Home
O
Config.
Configure
Library
Move
Cartridges
Configure
Options
Inventory
Tapes
Calibrate
Library
Unload
Drive
Unload
Imp/Exp
Stop
About
Quantum|ATL
Comentarios a estos manuales