
Chapter 3 Quantum PX500 Series Remote Management
Setup
Quantum PX500 Series User’s Guide 122
1 To access the Date & Time page, from the Setup page, click on the Date
& Time
tab at the top of the page.
The Date & Time page displays (see figure 81).
Figure 81 Date & Time Page
2 Select Manual to manually set the system date and time using the
Change button for the system date and drop down boxes for the
system time.
3 Click Save when complete.
The Quantum PX500 Series will not use the new date and time zone
information until it has been rebooted.
Library 3
The library configuration section allows the user to configure automatic
library settings.
1 To access the Library page, from the Setup page, click on the Library
tab at the top of the page.
Note: The library must be offline to change the library settings.
Comentarios a estos manuales