Quantum DAT 240 Loader Manual de usuario descargar pdf (Pagina 29)

Installation

Connecting the SCSI interface cable

The Scorpion 240 provides two 68-pin, shielded connectors on the rear panel of the

enclosure. Either connector can be used as a SCSI IN or SCSI OUT connection (you

can use either connector to attach the drive to the host computer or to another SCSI

device).

Turn off your computer and all SCSI devices. Then attach a SCSI cable from the

host adapter or from another (unterminated) SCSI device to the Scorpion 240.

Note: The Scorpion 240 will not operate in a SCSI-1 environment.

SCSI Termination

If the Scorpion 240 is the last device or the only device in a SCSI chain, you must

install a terminating plug on the unused SCSI connector. See Figure 10 for two SCSI

termination examples. You can purchase a terminator for the Scorpion 240 (part

number 10006525-001) on the web at http://buytape.seagate.com.

External

Tape Drive

SCSI Controller

(termination enabled)

External

SCSI device

External

Tape Drive

SCSI Terminators

SCSI Controller

(termination disabled)

Internal

SCSI device

(

termination

enabled

)

Example 1: SCSI termination

in a system that has only

external SCSI devices.

External

SCSI device

Example 2: SCSI termination

in a system that has both

internal and external SCSI

devices.

Figure 10. SCSI termination examples for external Scorpion 240

Connecting the power cord

Attach the power cord securely to the power connector on the back of the drive. The

location of the power connector is shown in Figure 9 on the previous page.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 50 51

Comentarios a estos manuales

Sin comentarios

Quantum DAT 240 Loader Manual de usuario Pagina 29

Comentarios a estos manuales

Relacionado con productos y manuales para Las unidades de cinta Quantum DAT 240 Loader