
Chapter 2 Installing the L500 Series Library
Connecting the Tape Library
22 Quantum|ATL PowerStor L500 Series Tape Library User’s Guide
Connecting the Tape Library
2
Complete the following procedure to connect the power cord and
SCSI signal cables to the tape library. Figure 17
shows the rear
panel layout for a three-drive configuration.
Figure 17 Tape
Library Rear Panel
Cable Connectors
Caution: Verify that the library card uses the same type of
SCSI bus as the drives. For example, connecting a
single-ended (SE) SCSI library to a differential (DIFF)
SCSI adapter will cause a host system malfunction.
Power switch and
Library card
SCSI ID 0
to host
Library card
SCSI ID 0
to drives
Drive 1
SCSI ID 2
Drive 2
SCSI ID 3
Drive 0
SCSI ID 1
power connector
Comentarios a estos manuales