Quantum LTO 4 Guía de usuario Pagina 88
- Pagina / 98
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Appendix A Installation Checklists
Tabletop LTO-4 (Model B) Half-Height Tape Drive Quick Start
72 LTO-4 (Model B) Half-Height Tape Drive User’s Guide
Tabletop LTO-4 (Model B) Half-Height Tape Drive Quick
Start
Use the following quick-start procedure to install tabletop LTO-4 (Model
B) Half-Height Tape Drive. Print this page and check each step as you
complete it. If you need more information about a step, see the
subsection referenced in the step.
q 3 Connect a serial-attached SCSI (SAS) interface cable to the drive.
See Connecting the Internal Drive Interface and DC Power Cables
on page 13.
q 4 Connect a serial cable, if installing the tape drive in a tape library system.
See Connecting the Internal Drive Interface and DC Power Cables
on page 13.
q 5 Connect a DC power cable to the drive.
See Connecting the Internal Drive Interface and DC Power Cables
on page 13.
q 6 Replace the computer covers and AC power cable, turn on the computer, and
verify that the internal tape drive is operating properly.
q 7 Register your tape drive.
See Registering the LTO-4 (Model B) Half-Height Tape Drive
on page 23.
q 1 Unpack the contents of your drive package, and check for damaged items.
See Unpacking and Inspecting the Drive
on page 8.
q 2 Connect a serial-attached SCSI (SAS) interface cable to the drive.
See Connecting the Internal Drive Interface and DC Power Cables
on page 13.
q 3 Connect a power cable to the drive.
See Connecting the Tabletop Drive Interface and AC Power Cables
on page 18.
- LTO-4 (Model B) 1
- Contents 3
- Chapter 3 Operation 25 4
- Chapter 4 Theory 35 4
- Chapter 5 Specifications 43 4
- Index 81 6
- Standards Conformance 13
- (Corporate Headquarters) 14
- Technical Publications 15
- Quantum Home Page 15
- Getting More 15
- Information or Help 15
- Worldwide End-User 16
- Product Warranty 16
- Introduction 17
- Drive Models 18
- Features 19
- Chapter 1 Introduction 20
- Installation Procedures 21
- Handling Precautions 22
- Guidelines 22
- Preinstallation 23
- Requirements 23
- Ta p e D r i v e 24
- Configuring the 25
- Internal Parallel SCSI 25
- Ta p e Drive 25
- ID Configuration Jumper Pins 26
- Bus Termination Examples 27
- Mounting the Internal 28
- Connecting the Internal 29
- Drive Interface and DC 29
- Power Cables 29
- DC power connector 30
- 68-pin SCSI cable 30
- 29-pin SFF-8482 SAS connector 30
- Restarting the Internal 31
- Tape Drive System 31
- Tabletop Parallel SCSI 33
- Connecting the 34
- Tabletop Drive Interface 34
- AC power connector 35
- AC power switch 35
- Restarting the Tabletop 38
- Drive System 38
- Operation 41
- Chapter 3 Operation 42
- Table 2 Front Panel Display 44
- LED Blink Codes 44
- Using LTO Tape Cartridges 46
- Write Protecting a Tape 47
- Cartridge 47
- Tape Cartridge Care and 48
- Maintenance 48
- Cleaning the Tape Drive 49
- Chapter 4 51
- Track Layout 51
- Chapter 4 Theory 52
- Recording Method 53
- Data Buffer 53
- Data Integrity 53
- Error-correction Code 54
- Data Compression 55
- Considerations 56
- Intelligent Data 57
- Compression 57
- Specifications 59
- TO CARTRIDGE CENTER 60
- FROM BOTTOM MOUNTING SURFACE 60
- FROM SIDE MOUNTING SURFACE 60
- Power Specifications 61
- Chapter 5 Specifications 62
- Table 5 Power Dissipation 62
- Table 6 Drive Performance 63
- Environmental Requirements 64
- Injected Noise Specifications 65
- Reliability Specifications 65
- Mean Time Between 66
- Failures 66
- LTO Cartridge Specifications 67
- Troubleshooting Guide 69
- Troubleshooting Suggestions 70
- Computer Hardware 71
- Does Not Recognize the 71
- Computer Software 72
- Does Not Recognized 72
- Slow Backup 73
- Operations 73
- Failed Operations 76
- TapeAlert Messages 76
- Understanding LED Sequences 82
- Table 10 Tape Drive LED 83
- Sequences 83
- Installation Checklists 87
- Appendix B 91
- Equipment 91
- Appendix C 93
- Regulatory Compliances 93
- Safety Compliances 93
Relacionado con productos y manuales para Las unidades de cinta Quantum LTO 4
Las unidades de cinta Quantum DLT 7000 Manual
(312 paginas)
(312 paginas)
Las unidades de cinta Quantum DLT 2500 Manual
(12 paginas)
(12 paginas)
Las unidades de cinta Quantum DLT 4000 Manual
(300 paginas)
(300 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.093 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales