Quantum GoVault Guía de usuario descargar pdf (Pagina 26)

Chapter 2 Installation Procedures

Installing the Internal GoVault Dock

GoVault™ for Windows User’s Guide 14

14 Use Windows My Computer to verify successful GoVault installation

and configuration (see figure 9

15 Perform a number of file copy operations to and from the GoVault

cartridge to verify the disk write/read functions.

16 If you are going to install both the GoVault system application

software and the backup application software, then proceed to

nstalling the GoVault System Application Software in the next

subsection.

If you are not going to install the GoVault system application

software, then skip to Installing the Backup Application Software

page 23.

Figure 9 Successful

Configuration Display

Note: If you do not install the GoVault system application

software, the Windows operating system might assign the

low-speed Programmed I/O (PIO) mode for GoVault data

transfer operations. Use the procedures in appendix B,

Configuring Windows for DMA Data Transfer Mode, on

page 66 to determine if this is the case and, if necessary,

configure the operating system to use the high-speed

Direct Memory Access (DMA) mode for GoVault data

transfer operations.

GoVault

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 90 91

Sin comentarios

Quantum GoVault Guía de usuario Pagina 26