
Chapter 2 Installation Procedures
Installing the GoVault System Application Software
GoVault™ for Windows User’s Guide 16
7 Insert a GoVault cartridge into the dock and verify that the front
panel activity LED indicator signifies a successful cartridge load
operation (see Inserting Cartridges
on page 21).
8 Perform a number of file copy operations to and from the GoVault
cartridge to verify the disk write/read functions.
9 If you are going to install both the GoVault system application
software and the backup application software, then proceed to
I
nstalling the GoVault System Application Software in the next
subsection.
If you are not going to install the GoVault system application
software, then skip to Installing the Backup Application Software
on
page 23..
Installing the GoVault System Application Software
After installing the GoVault dock and cartridge disk drive and verifying
that your operating system recognizes the drive, use one of the three
system application applets on the GoVault Resource CD to install the
GoVault system application software.
Each applet provides an installation package that corresponds to one of
the three types of supported operating systems:
•
x64
• x86
• IA64
Note: If you do not install the GoVault system application
software, the Windows operating system might assign the
low-speed Programmed I/O (PIO) mode for GoVault data
transfer operations. Use the procedures in appendix B,
Configuring Windows for DMA Data Transfer Mode, on
page 66 to determine if this is the case and, if necessary,
configure the operating system to use the high-speed
Direct Memory Access (DMA) mode for GoVault data
transfer operations.
Comentarios a estos manuales