Quantum DLT 4700 Guía de instalación descargar pdf (Pagina 16)

Configuring Your IP4700 Device for Use with Backup Software

Configuring Veritas NetBackup Software

The IP4700 Administration screen displays the tape drives or libraries

that are connected to the system, as shown in the following example.

This example shows one DLT7000 drive on SP A and two tape drives

on SP B, one DLT7000 and one AIT-2. SP A’s drive has Quantum

firmware V95; whereas, SP B’s DLT has Quantum firmware V100.

The AIT-2 drive has firmware 2.00.

As long as the screen displays the tape drives, you can use them;

however, the tape drive report does not guarantee that the tapes will

write and read properly. When the IP4700 system comes up and scans

the SCSI buses to locate tape drives, the SCSI commands it runs do

not perform synchronous SCSI transfer.

Configuring Veritas NetBackup Software

This section describes how to configure Veritas NetBackup software

for standalone tape drives, local tape libraries, three-way backup, and

mapped network drive backup. It also describes the SnapView and

Fast Incremental features that you can use with backup.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 57 58

Sin comentarios

Quantum DLT 4700 Guía de instalación Pagina 16