Quantum DLT 4700 Guía de instalación descargar pdf (Pagina 18)

Configuring Your IP4700 Device for Use with Backup Software

Configuring Veritas NetBackup Software

Configuring

NetBackup for

Standalone Tape

Drives

This section describes how to set up an NDMP login and create a

device, storage unit, and class when configuring NetBackup for

standalone tape drives. It also describes how to test the tape drive

and perform a test backup after you have configured the NetBackup

software.

Setting Up an NDMP

You must inform NetBackup how to log in to the NDMP hosts. For

each IP4700 SP, set up the NDMP login as follows:

1. From the UNIX prompt, type cd install_path/volmgr/bin, or

from the Windows prompt, cd install_path\volmgr\bin.

install_path is where the Veritas NetBackup software is installed.

2. Type set_ndmp_attr -auth hostname username.

Hostname is the host name you defined for the SP, and username

is the NDMP user you defined on the IP4700.

The NDMP username is always Administrator, no matter what name the

administrative account uses. The NDMP account password is the same

as the IP4700 administrative password. It cannot be a null password.

3. At the prompts for the password, type the password for the

IP4700 administrative account.

4. To verify proper authorization, type

set_ndmp_attr -verify hostname

If the server can log in to the IP4700, the message, login

successful appears. If not, make sure you have used the

correct user name and password.

Continue the NetBackup configuration by creating the device,

storage unit, and class, using the NetBackup graphical user interface.

Creating a Device To create a device, follow these steps:

1. From the NetBackup Administration window, click Media and

Device Manager.

2. From the Media and Device Management NetBackup window,

select Actions

→ New Drive.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 57 58

Sin comentarios

Quantum DLT 4700 Guía de instalación Pagina 18