Quantum Scalar 50 Manual de usuario descargar pdf (Pagina 11)

Quantum Scalar 50 Tape Drive Installation Instructions

Document 81-81769-02 A01

July 2008

Setting the Tape Drive SCSI ID 11

There are two ways to set the tape drive SCSI ID:

• Setting the SCSI ID Using the OCP

• Setting the SCSI ID from the Remote Management Pages

Setting the SCSI ID

Using the OCP

To set the tape drive SCSI ID on an Scalar 50 Series library with an LCD:

1 From the operator control panel (OCP), press

Setup from the Home

screen. The OCP displays the

Setup screen (see figure 10):

Figure 10 Setup Screen

2 Use the up and down arrows to highlight Cabinet and press Enter.

The

Cabinet screen displays (see figure 11):

Figure 11 Library Options

Screen

3 Use the up and down arrows to highlight Host bus and press Enter.

The

Host bus screen displays (see figure 12):

Note: SAS tape drives do not require a SCSI ID and cannot be

configured. Used the default tape drive configuration

information.

Note: Surrogate control is set via the

Partition page on the remote

management pages.

Enter

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 23 24

Sin comentarios

Quantum Scalar 50 Manual de usuario Pagina 11