Quantum Scalar 50 Manual de usuario descargar pdf (Pagina 7)

Quantum Scalar 50 Tape Drive Installation Instructions

Document 81-81769-02 A01

July 2008

Cabling the Tape Drives 7

3 Insert the tape drive into the drive bay slowly until the connectors are

seated (see figure 3

4 Tighten the tape drive captive screws using a flat blade screwdriver.

5 Repeat steps 1

through 4 to install another tape drive in a different

location, if desired.

Figure 3 Installing a Tape

Drive

Proceed to Cabling the Tape Drives.

Cabling the Tape Drives 0

After the tape drive(s) have been installed, you must connect SCSI, SAS or

Fibre Channel cables to each drive.

Refer to the following figures to cable the tape drives:

• Figure 4

SCSI full height drives

• Figure 5

Native Fibre Channel full height drives

• Figure 6

SCSI half-height drives

• Figure 7

SAS half-height drives (Surrogate mode SCB only)

• Figure 8

Native Fibre Channel half- height drives

• Figure 9

Stacked Library Configuration

Tape drive 1

Captive screw

Tape drive 2

Captive screw

1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

Sin comentarios

Quantum Scalar 50 Manual de usuario Pagina 7