
Quantum Scalar 50 Tape Drive Installation Instructions
Document 81-81769-02 A01
July 2008
Completing the Native Fibre Channel Installation 15
Completing the Native Fibre Channel Installation 0
After native Fibre Channel tape drives are installed, additional information
must be gathered to complete the installation and verify connectivity.
Competing the native Fibre Channel tape drive installation consists of the
following steps:
• Determining the WWNs World Wide Names
• Verifying Library Connectivity
Determining the
WWNs World Wide
Names
0
The media changer (robot) and tape drives within the library have WWNs
World Wide Names assigned to them by the system controller board (SCB).
The WWNs must be determined and recorded both for the customer and for
Quantum customer support. This information is important when replacing
the Fibre Channel SCB and tape drives. Using the following procedures,
complete table 3
and retain a copy of the table for your records. Have this
table available when contacting Quantum Customer Support for any library
or tape drive connectivity issues.
Table 3 Library World
Wide Names
Using the Remote Management to Determine the WWNs 0
To determine the WWNs from the library remote management pages:
1 On the host computer, open the internet browser software.
2 In the
Address field, type http://IPaddress/ where IP address is the IP
address for the Quantum Scalar 50 series library.
3 Enter the username and password and click
OK.
The
Overview page displays (see figure 17):
Library/Tape Drive World Wide Name (e.g. 50:05:08:40:00:16:47:00)
Media Changer
(robot)
Tape drive 1
Tape drive 2
Tape drive 3
Tape drive 4
Note: The default username and password is
admin.
Comentarios a estos manuales