Quantum 200D/400D Guía de usuario Pagina 46

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 65
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 45
34 Troubleshooting and Diagnostics
LCD
Force Drive Dump
Completed!
which will change to:
Ultrium Tape Drive
Drive Empty
The single-character display will then blank (turn off), the drive will exit Maintenance Mode and the front panel
indicators display the following:
Indicator State, Character, or Message
Status LED
Off
Single-character display Off
LCD
Ultrium Tape Drive
Drive Empty
Note
You can also perform this function while the drive is in the normal
operating mode. Simply press and hold the Unload button for 10
seconds.
Copy the Drive Dump to Tape [at Beginning of Tape (BOT)]
Use this function to direct the drive to copy data from a drive dump (refer to Function 4–Force a Drive Dump, above) to the beginning of
a scratch tape.
To select the Copy the Drive Dump to Tape function, perform the following steps:
1. Verify that the drive is in Maintenance Mode shown when the Status LED is solid amber.
2. Press the Unload button once per second until the front panel indicators display the following:
Indicator State, Character, or Message
Status LED
Amber, solid
Single-character display
5
LCD
Maint Mode: Select
Copy Dump to Tape
3. Press and hold the Unload button for two seconds to select Copy Dump to Tape. The front panel indicators will display
the following:
Indicator State, Character, or Message
Status LED
Amber, solid
Single-character display
c, flashing
LCD
Copy Dump to Tape
Load Scratch Tape
Vista de pagina 45
1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 64 65

Comentarios a estos manuales

Sin comentarios