Quantum 200D/400D Guía de usuario descargar pdf (Pagina 49)

Troubleshooting and Diagnostics 37

If the test fails, the front panel indicators display the following:

Indicator State, Character, or Message

Status LED

Amber, flashing

Single-character display

8, solid

LCD

Error!

Drive/SCSI Bus Error

Then the drive will exit Maintenance Mode.

To resolve the error, refer to Table 4-2 Error Codes, elsewhere in this chapter. To clear the error, cycle (remove, then

reapply) power to the LTO standalone.

Unmake FMR Tape

Use this function to direct the drive to erase the firmware data on a scratch data cartridge and rewrite the cartridge memory on tape. This

turns the cartridge into a valid scratch data cartridge.

To select the Unmake FMR Tape function, perform the following steps:

1. Verify that the drive is in Maintenance Mode shown when the Status LED is solid amber.

2. Press the Unload button once per second until the front panel indicators display the following:

Indicator State, Character, or Message

Status LED

Amber, solid

Single-character display

LCD

Maint Mode: Select

Unmake FMR Tape

3. Press and hold the Unload button for two seconds to select Unmake FMR Tape. The front panel indicators display the

following:

Indicator State, Character, or Message

Status LED

Amber, solid

Single-character display

c, flashing

LCD

Unmake FMR Tape

Load Drv FMR Tape

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 64 65

Sin comentarios

Quantum 200D/400D Guía de usuario Pagina 49