Quantum 200D/400D Guía de usuario descargar pdf (Pagina 50)

38 Troubleshooting and Diagnostics

4. Within 60 seconds, insert the FMR cartridge (or the drive will exit Maintenance Mode).

After you insert the cartridge, the front panel indicators display the following:

Indicator State, Character, or Message

Status LED

Amber, solid

Single-character display

8, flashing

LCD

Unmake FMR Tape

Tape Loading ====

while the drive loads the FMR tape, then erases the firmware on the tape,

then rewrites the header in the cartridge memory to change the cartridge to a

valid scratch data cartridge.

If the operation is successful, the front panel indicators display the following:

Indicator State, Character, or Message

Status LED

Amber, solid

Single-character display

0, solid

LCD

Unmake FMR Tape

Completed!

followed by:

Cartridge Unloading

In Progress

followed by:

Ultrium Tape Drive

Drive Empty

The drive will then exit Maintenance Mode.

If the operation is not successful or the tape is already a valid scratch tape, the front panel indicators display the following:

Indicator State, Character, or Message

Status LED

Amber, solid

Single-character display

7, flashing

LCD

ERROR!

Media Error

To resolve the error, refer to Table 4-2 Error Codes, elsewhere in this chapter. To clear the error, cycle (remove, then

reapply) power to the LTO standalone.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 64 65

Sin comentarios

Quantum 200D/400D Guía de usuario Pagina 50